FiberCube 3601 Series Open Laser Engraving System – Quick Setup Guide

FIBERCUBE QUICK SETUP GUIDE

17. Using the supplied USB cable, plug one end into the USB port on the back of the machine.

20 watt model shown

Be sure to tighten the thumb screws

30 watt model shown

18. For 30 watt models only Identify the pendant below and attach the connector to the interface port.

FiberCube ® 3601 Series – Quick Setup Guide, Rev. C_02-10-23 PN 58–9990–558–361

© 2023 LaserStar Technologies Corporation. All rights reserved.

W W W .

LASERSTAR.

N E T