FiberStar 7601 Series Quick Setup Guide

FIBERSTAR QUICK SETUP GUIDE

21. Retrieve the small metal stand from the accessory kit (provided). Place the stand below the scope and look through the scope.Adjust the height of the metal stand until clear focus is achieved.Then, lock down the four (4) thumb screws.Adjust the scope to achieve precise clarity and focus. (Note: If the stand does not reach the proper height, remove the thumb screws and place them in the alternate holes.)

CROSS-HAIR ALIGNMENT

22. Touch the number on the top left (79 in these images), then touch the Safety Shutter button (see second image). The dot in the button should now be green, as shown in image 3.

23. Touch the Arrow buttons on the touch screen and select memory cell #1 TEST SETTING by using the Up or Down Arrow buttons .

FiberStar ® 7601 Series – Quick Setup Guide, Rev. A_09-29-23

PN 87–9990–558–761

© 2023 LaserStar Technologies Corporation. All rights reserved.

W W W .

LASERSTAR.

N E T