LaserStar 7802 Series Quick Setup Guide

LASERSTAR QUICK SETUP GUIDE

INSTALLING THE LIGHTS

If the laser is equipped with a ring lamp, the lamp has been previously installed, and you can proceed with powering up the machine by turning on the key switch; the ring lamp will then power up.

(Note: If the lamp does not power up, turn the black knob at the front of the laser clockwise until it turns on.)

MOUNTING THE MICROSCOPE

35. Remove the scope from its box and take off the plastic cap that protects the flange.

LaserStar ® 7802 Series – Quick Setup Guide, Rev. A_04-30-24

PN 87–9990–558–782

© 2023 LaserStar Technologies Corporation. All rights reserved.

W W W .

LASERSTAR.

N E T